Cable Clamp Proper Installation

Turn the hex nuts attached to the wire rope clamps counterclockwise to remove the u bolt from the saddle of the clamp.

Cable clamp proper installation.

These cable clamps are not to be removed. Apply the second clip as close to the. The u part goes over the dead end while the live end rests in the clip saddle. About 1 2 inch of outer cable sheathing should extend into the box past the cable clamp.

Apply u bolt over dead end of wire rope live end rests in saddle never saddle a dead horse tighten nuts evenly alternate from one nut to the other until reaching the recommended torque. Wire rope clips may also be referred to as wire rope clamps cable clamps wire clamps wire clips u bolts or other local terms. These typically all refer to the same group of products. Install the thimble in.

Apply the first cable clip one base width from the dead end of the wire rope. Place the cable into the body of the clip and work it into the grooves and around the bolts leaving at least 2 cable diameters of dead end protruding from the body. Pre tension the system by pulling the wire rope through the combo clamp with the two nuts bolts loosened. If you are seeking information on the proper installation of wire rope clips please look to our wire rope clip page our youtube channel.

314 17 c states that cables must be secured to the receptacle box. Form the eye to the size you require and work the cable into the other side. Here are some standard practices to follow to make your wiring installations look like the work of a pro. How to install steel cable clamps step 1.

The u bolt will slide over the dead end of the wire rope. If a torque measuring device is not available tighten the nuts bolts as tight as possible. Turn back specified amount of rope from thimble or loop. Article 334 30 states that cables coming out of the junction boxes should be secured within 12 inches of the box in all boxes equipped with cable clamps.

The correct way is to double over each end of the line and use 3 crosby clamps on each side 6 total clamps. Wire rope cable clips follow the steps below to install u bolt clips correctly. Additionally never put the saddle end of the clamp on the short or dead leg of the wire rope. Apply first clip one base width from dead end of rope.

Grasp the steel cable firmly and form a loop leaving the recommended length of cable on the short side. This part should be underneath the rope. Tighten the nuts evenly to the recommended torque. Lapped with 3 crosby clamps.

The ensures that the cable will. Crosby clamps are not to be staggered. Although in article 314 17 c s exception nonmetallic boxes have no cable clamps and must have cables supported within eight inches of the junction box. Prepare and attach the wire rope clamps.